Design and realization of an energy harvester using pulsating arterial pressure. 


Author: Pfenniger A, Wickramarathna LN, Vogel R, Koch VM.

Affiliation: Engineering and Information Technology, Bern University of Applied Sciences, Switzerland; ARTORG Center for Biomedical Engineering Research, University of Bern, Switzerland. Electronic address: alois.pfenniger@artorg.unibe.ch. 
Conference/Journal: Med Eng Phys.
Date published: 2013 Feb 12
Other:
  Pages: S1350-4533(13)00011-8   ,  Special Notes: doi: 10.1016/j.medengphy.2013.01.001   ,  Word Count: 207  
    

Most medical implants run on batteries, which require costly and tedious replacement or recharging. It is believed that micro-generators utilizing intracorporeal energy could solve these problems. However, such generators do not, at this time, meet the energy requirements of medical implants.This paper highlights some essential aspects of designing and implementing a power source that scavenges energy from arterial expansion and contraction to operate an implanted medical device. After evaluating various potentially viable transduction mechanisms, the fabricated prototype employs an electromagnetic transduction mechanism. The artery is inserted into a laboratory-fabricated flexible coil which is permitted to freely deform in a magnetic field. This work also investigates the effects of the arterial wall's material properties on energy harvesting potential. For that purpose, two types of arteries (Penrose X-ray tube, which behave elastically, and an artery of a Göttinger minipig, which behaves viscoelastically) were tested. No noticeable difference could be observed between these two cases. For the pig artery, average harvestable power was 42nW. Moreover, peak power was 2.38μW. Both values are higher than those of the current state of the art (6nW/16nW). A theoretical modelling of the prototype was developed and compared to the experimental results.

Copyright © 2013 IPEM. Published by Elsevier Ltd. All rights reserved.

PMID: 23414917